Walls Finished Without Waiting on Another Crew

Drywall Installation in Arlington for homes with hard-to-match plaster or textured walls built decades ago

If you open a wall to move plumbing or electrical lines, or if you remove a partition to open a floor plan, the new drywall must be feathered carefully into existing surfaces to avoid visible seams, particularly in older DFW homes where plaster or texture is hard to match. JC Remodeling in Arlington hangs and finishes drywall as part of interior remodels, including repairs, new walls and popcorn ceiling removal followed by texture and repainting. Drywall is handled by the same contractor who runs the plumbing, electrical and paint, so the wall is ready for finish work without waiting on another crew.


Walls are opened or removed as needed, new board is hung and screwed to framing, and seams are taped and coated in several thin layers. Each coat is sanded before the next, then surfaces are primed and textured to match the rest of the house before painting. In homes with existing knockdown or orange peel texture, the new section is blended into the surrounding finish so the repair does not stand out under angled light.


Request a detailed estimate based on the scope of your wall repair or addition.

Unfinished room with dark drywall, visible joint compound, an arched window, and protective floor covering.

How the Surface Is Prepared and Blended

New drywall is cut to fit the opening, fastened to studs or ceiling joists with screws spaced according to code, and all seams are covered with paper tape embedded in joint compound. Multiple coats are applied and sanded to feather the seam into the surrounding surface, and corners are reinforced with bead or tape depending on the location. Because JC Remodeling handles the texture and paint after the board is hung, the new section is blended into the existing finish without coordinating a separate finisher.


You notice that the seam disappears under both direct and angled light, the texture matches the pattern and depth of the surrounding wall, and the paint sheen is consistent across the repaired area. The surface feels smooth when you run your hand across it, with no ridges or depressions marking where the repair was made.


The work includes board installation, taping, multiple coats of joint compound, sanding, priming, texture and paint. Structural framing, insulation and vapor barrier installation are handled as part of the same remodel but are separate steps completed before the drywall is hung.

Answers About How the Work Is Done

These questions address how drywall is hung, finished and blended into existing walls in homes across North Richland Hills and Euless where texture and finish vary widely.

  • How is new drywall blended into existing textured walls?

    The seams are taped and coated in thin layers, sanded smooth, then primed and textured to match the surrounding finish using a spray gun, roller or trowel depending on the pattern.

  • What happens between each coat of joint compound?

    Each coat is allowed to dry completely, then sanded to feather the edges and remove high spots before the next coat is applied, which prevents ridges from building up at the seam.

  • Why does the same contractor handle texture and paint after hanging drywall?

    Because JC Remodeling runs the plumbing, electrical and finish work, the wall is ready for trim and fixtures without waiting on another company to complete the texture and paint.

  • How are corners and edges finished where new drywall meets existing surfaces?

    Outside corners are reinforced with metal or vinyl bead, inside corners are taped and coated, and edges that meet existing plaster or drywall are feathered with compound to create a smooth transition.

  • What should you check once the drywall is finished and painted?

    The seam should not be visible under angled light, the texture should match the surrounding wall in pattern and depth, and the paint sheen should be consistent across the repaired and existing areas.

JC Remodeling also hangs and finishes drywall in Grand Prairie, Fort Worth, Mansfield, Grapevine and Euless. Arrange an on-site consultation to review the areas that need repair or new wall construction.